Bushnell Saw LS1440 User Manual

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.ENGLISHMiter SawMODE

10Slip the pin on the blade guard into the slot in the guide arm while returning theblade guard to its original fully closed position. Then tighten th

11Horizontal vise (Accessory)The horizontal vise can be installed on either the left or right side of the base.When performing 15° or greater miter cu

12leave a mark (saw mark) in the workpiece and the precision of the cut willbe impaired.1. Press cuttingSecure the workpiece with the vise. Switch on

13After changing the miter angle, cut the wood facing at that selectedangle. If there is a gap between the blade, the wood facing and the work-piece,

14MAINTENANCECAUTION:• Always be sure that the tool is switched off and unplugged beforeattempting to perform inspection or maintenance.WARNING:• Alwa

15Adjusting for smooth handle actionThe hex lock nut which holds the gear housing and the arm has been factoryadjusted to assure smooth handle action

16ACCESSORIESCAUTION:• These accessories or attachments are recommended for use with your Makita tool specified in this manual. Theuse of any other ac

Memo17

Memo18

Memo19

2SPECIFICATIONSBlade diameter...

Makita Corporation883619D8

3GENERAL SAFETY RULES GEA001-3WARNING:Read all instructions. Failure to follow all instructions listed below may result inelectric shock, fire and/or

4or storing power tools. Such preventive safetymeasures reduce the risk of starting the power toolaccidentally.19. Store idle power tools out of the r

527. Select saw blades in relation to the material tobe cut.28. Take care when slotting.29. Replace the kerf board when worn.30. Do not use saw blades

6INSTALLATIONBench mountingWhen the tool is shipped, the handle is locked in the lowered position by thehandle latch. Release the handle latch by lowe

7Kerf boardThis tool is provided with the kerf board in the turn base to minimize tearing onthe exit side of a cut. If the kerf groove has not yet bee

8Fence plateThe fence plate is designed to prevent smaller cutting scraps from jamminginside the blade case. The fence plate moves right or left autom

9Press the shaft lock to lock the spindle and use the socket wrench to loosenthe hex bolt counterclockwise. Then remove the hex bolt, outer flange and