Bushnell 18-0833 User Manual download pdf (Page 6)

How to Take A Still Photo

After following the initial setup as described in the previous section, you are ready to take a photo:

1) Turn on the power, raise the LCD display, and be sure the still photo/video switch is in the “still” (left) position.

2) The Instant Replay will default to the highest resolution and quality settings, as well as “everything on automatic”

when it is turned on for the ﬁrst time. If you prefer to use different settings, refer to the section “Using the Main

Menu” for directions regarding how to ﬁnd and change these settings.

3) Aim and focus on your subject while looking through the binocular.

4) Before taking a photo, check to make sure the subject appears sharp on the LCD. Pressing the “Up” arrow button

will provide a 3x magniﬁed preview that can help you ﬁne tune the focus. Use the center focus knob if any adjustment

is necessary.

5) Hold the camera as steady as possible with both hands and slowly squeeze the Shutter button. The display will go

dark brieﬂy while the ﬁle is stored, then you are ready to take another photo. The counter in the lower right corner will

change to display the remaining photo capacity, which depends on the amount of internal or card memory available,

as well as the resolution and quality settings (you may switch to lower settings at any time to “ﬁt” more photos in the

remaining memory). Note: the counter will not always go down by one number after each photo is taken, depending on

resolution/quality settings and the photo subject, lighting, and other factors. When the counter reaches “000”, you are out

of memory (storage space) and should download photos you wish to keep so they may be deleted, or you may remove

and install another compact ﬂash card.

6) Press the Display button if you wish to check the photo after you take it, then press “Display” again to return to a

live preview. See the section “Reviewing & Deleting Photos” for more regarding reviewing previously taken photos.

You are now ﬁnished setting up the binocular optics, and can just use the center knob (as you would on any standard

binocular) to focus for any future photos or videos you take with the Instant Replay. To assure optimum sharpness,

check your focus on the LCD, and adjust the center knob if necessary, before you snap the shutter.

Basic Binocular and Camera Setup continued How to Shoot A Video Clip

1) Turn on the power, raise the LCD display, and be sure the still photo/video switch is in the “video” (right) posi-

tion.

2) Resolution and quality are ﬁxed for video clips, but you may change the settings for Camera menu items such as:

EV (exposure ), White Balance, and ISO (light sensitivity). See “Using the Main Menu” for directions.

3) Aim and focus on your subject while looking through the binocular.

4) Before shooting the video, check to make sure the subject appears sharp on the LCD. Pressing the “Up” arrow

button will provide a 3x magniﬁed preview that can help you ﬁne tune the focus. Use the center focus knob if any

adjustment is necessary.

5) Hold the camera as steady as possible with both hands and slowly squeeze the Shutter button to begin shooting

video. The counter in the lower right corner of the LCD display will show the total seconds elapsed since you started

recording. After every 30 seconds of recording, the video will begin to “loop”-the key to the Instant Replay concept.

This means it will start recording over the previous video from the beginning, replacing it with the new events. The

counter will continue to advance normally, past 30 seconds. Right after the end of an exciting moment, press Shutter

to stop recording the loop. The power indicator light will turn yellow, and the LCD displays a ﬁle folder icon for a

few seconds, as the video loop (most recent 30 seconds of action) is being saved to the internal or card memory.

6) After the video ﬁle is done saving (power indicator will return to green, folder icon is gone), press the “Display”

button (you will see the ﬁrst frame of your most recently recorded video), then press the right arrow button to play

the video clip. Press Display again to return to a live preview. See the section “Reviewing & Deleting Photos” for

more regarding reviewing previously taken videos.

18-0833 6LIM.indd 10-11 1/28/05 2:47:40 PM

1 2 3 4 5 6 7 8 9 10 11 ... 72 73

Comments to this Manuals

No comments

Bushnell 18-0833 User Manual Page 6

Comments to this Manuals

Related products and manuals for Optical devices Bushnell 18-0833